These locks are important for keeping your patio doors secure so it s important that you replace yours promptly if it s not working while you might need to completely replace your lock it s possible you just need to replace the latch.
Fix sliding door latch.
You may also want to check out our step by step guide to adjusting your sliding doors.
Raise it just enough to clear the track and roll smoothly.
To start your sliding glass door adjustment project first lift or lower the door on the track with a screwdriver or allen wrench.
Try applying lubricant such as a petroleum based oil or wd 40 in the area to see if that works.
Sometimes patio doors become hard to open even when the track is clean.
Make sure the rollers at the top are aligned first then walk the bottom of the door.
You can easily find a sliding glass door lock at your local hardware store or home center and if you remove the broken door lock and handle and take it to the store with you it will be easier to find a match.
Locate the two adjusting screws at the bottom of the door on the face or edge of the door and pry off the trim caps that cover the screws.
Step 2 remove the latch body.
Sometimes the sliding door may have a latch that works by sliding a small notch up and down.
Prime line 3 93 in surface mounted sliding patio door handle.
White stainless steel sliding patio door double bolt lock sliding patio door double bolt lock.
The fix in instances with a door latch stuck because it is jammed by rust and other materials it is always best to disassemble the lock and do a bit of cleaning.
Fix a sliding glass door lock fixing a sliding glass door lock is a very quick repair.
In addition to cleaning and lubricating sliding door tracks you want to lubricate the door lock.
Most sliding doors manage to get knocked off kilter at one point or another.
The best way to lubricate any lock is to disassemble it and use an aerosol lubricant to flush away grime and coat the moving parts of the lock.
To realign your door in the tracks at the top and bottom of the frame remove the door from the track and reinsert it.
Letting the components sit fully submerged in a vinegar of about 5 acidity will do the job of separating the gunk from your metal.